Lockitall                                              LOCKIT 2 r A.01
______________________________________________________________________

              User Manual: Lockitall LockIT 2, rev a.01
______________________________________________________________________


OVERVIEW

    - Lockitall is under new management.
    - The lock has been put together from bits of leftover scrap from
      the old factory.


DETAILS

    The LockIT 2 A.02  is the second of a new series  of locks.  It is
    controlled by a  MSP430 microcontroller. The MSP430 is a very low-
    power device, chosen because we found several crates of old stock.

    This lock only accepts biometric and NFC inputs, and does not have
    a traditional password prompt.

    To support rapid  development cycles  this lock  accepts a program
    from the old password input prompt. The program must be signed  by
    Lockitall,  so  engineering  aren't  concerned  it  will  be  used
    maliciously. There are two programs, one of which is below  in hex
    format  and  is used in the factory to test proper lock operation.
    The  other  program,  not  reproduced here, is restricted and only
    available internally at Lockitall.

    Load address:
    8000

    Program text:
    3540088000450545054505450545054505450f433041

    Signature:
    8605e027f42368ea6bba9de66409f6a8ddedcd49614a4648281c47a7b4ad252f5639069b17ba8ff104d371e2d8a625b038f0750667364087e7987e40ea81510f

    This is Hardware Version Beta.

    This is Software Revision 02.



(c) 2021 LOCKITALL                                            Page 1/1